Club 80-90 Forums

Hi could anyone help , I have a 2.0lt type4 cu engine. I'm looking for the spacer that goes into the flywheel with the felt seal . Nobody seems to...

I’ve got a 1.8T converted Syncro (AUM stamped block, but cable throttle) with a custom mild-steel sump made by whoever did the conversion. The paint...

Hi all,

First time camper van buyer. Going to view a local T25 later, can anyone advise what to look out for with this particular model? TIA :)

Hi
I have a quite rare Reimo Primus hybrid high/pop top. I recently had the canvas replaced, but now one of the roof struts has failed (conveniently...

The family bus had a fail to proceed moment earlier and arrived back at SE Towers via flatbed. I was delighted when I got home and found it sat in...

I did a stupid thing and put the battery feed to the “little black box” onto the negative terminal in an utter brain dead moment. The diode on the...

Hi all, new member here, so please be gentle  :lol:  

I recently picked up my 1982 T25 (Leisure drive) and one thing I have noticed is that it seems...

Found this rattling round the door pocket where it's been stashed for an unknown number of years. The quality of the previous work on this van is......

Hi, heater has worked in the past, but latterly only at 1/2 speed fan. Now it's not working at all - fan comes on, but no click, after 30 secs the...

I am in the process of offering up a SMF clutch to my diesel bell housing.

The link on Brickwerks is really useful in identifying which parts of the...

Just bought a set of these, for those occasions when a conventional helmet gets in the way (underneath the front wheel arch in my case). They work...

Ok, so I have fresh air from the driver's vent and hot air as well. Air from all other vent's (including hot) just can't get anything out of the left...

I know why the vehicle speed signal is wrong and what I need to fix it but the ECU memory error is troubling and can anyone tell me what the...

Hi
I have a cover for my kameo that isnt best designed for a hi top and it is also somewhat flimsy.
Does anyone have advice/ experience on the best...

I'm working on secondhand info here so bear with me...

Woman and her mum have been out in her mum's camper, its a 1989 1.7 diesel. She's noticed...

I recentlt purchaced s CVc front lift assist kit that requires mounting to the ridges on the roof.. I hsve a frontrunner rack to fit so iv no option...

Hi , 

i have a rear main seal leak and removed the gearbox and have some wear marks on the clutch fingers. The clutch was fitted a few months...

So I've been sidetracked into a Type IV build lately and have been thinking about changing the conrods

It's an 1800 so has the 55mm crank journal...

Hi all, does anyone have one of the more recent Reimo mushroom/turret tops (with dampers/springs) they could take some measurements off?

I've got...

I’ve been trying to replace the slave cylinder on my ‘84 1.9 DG and have managed to get the new one in all fine, problem is with clutch/brake fluid...

nemigaparts.com/cat_spares/etka/volkswagen

Doesn't cover everything but does appear to list EU, US and ZA

Hi Guys. Had a good summer in Cybil with no problems at all (apart from wife locking us out once :D ). Always instant start.
Home on 26th Oct. Two...

Hello all,

We have an Autosleeper Trooper with a stuck passenger seat.
It won't swivel, nor will it move backwards and forwards.

Any suggestions on...

Hi, 1.6 td, my axiliary water pump is staying on and running the battery down, is there a relay somewhere that should shut the water pump down once...

Couple more questions . What is the order for the right hand switches? The wires seem a little tight in which ever way I fit the blinker switch and...

Has anyone updated an Holdsworth Conversion Bed to use a Westfalia seat hinge? Removed original Holdsworth water tank from underneath seat and want...

Anyone know the availability of the choke return spring? Min looked partialy detached but was also seemingly a little light on tension.. MAy just...

How don i set the tick over and co up

Hi all bit of a novice. Had my 1986 T25 1.9DG Petrol. Drove 10 miles and suddenly lost power. RAC came and found the fuel pump wasn't working.. Then...

With an EPAS conversion, is the actual steering colum shaft spliced? or is it less involved than that? 

I don't mind the weight most of the time but...

Going to replace my blower switch with a PWM controller whist I am in there replacing the sized blower. 

Don't suppose anyone has a 3d File for the...

Hi,

Does anyone know of any VW mechanics/garages in North Northumberland or Scottish Borders - roughly the Newcastle to Edinburgh area? I'm looking...

Please can anyone tell me what is the correct coil to use on my 2ltr cu petrol Aircooled , still running it's original DVAD dizzy with hall sensor...

Hi -not been on here for a while but hopefully some simple advice needed please.

Changing my gearbox oil - I've drained usual dark stinky oil out....

Hi all. Our '88 Autosleeper high top needs some significant bodywork repairs. We're in Hastings, can anyone recommend somewhere preferably in East...

We have a pop top that did not come with a mattress,
not sure but I could guess theres not a lot of space up there,
so its crucial to find (buy) a...

Hi Reg, trying to PM you regarding fuel pump. I think your inbox is full ;)

1985 Autosleeper maroon decals need touch up, slight scratches , read somewhere of a matching colour touch up pot -think it was Alpha Romeo maroon ,...

Hi just finished my type 25 AAZ conversion, with the aaz crank and serpentine pulley,i want to fit an alternator with a clutched pulley to eliminate...

Hello

My 1985 DG 1.9 WBX petrol fuel tank is out and rust treated with phosphoric acid after cleaning back to shinny metal
painted with Teamac Zinc...

Hello! I have a problem with the starting motor on a JX to AAZ engine conversion.
JX flywheel, JX Starting motor, AAZ engine.
When I tighten the two...

Hi all,

my 1.6td JX engine has head gasket issues and I've been recommended to have the engine replaced.
I tinker but this kind of work is beyond...

Obviously but still worth posting.
1.6D temp gauge at around 12 noon most of the time.but during warmer weather and running 50mph on motorway it will...

Dear all,

Apologies for the title - and the (probably) daft question. I have recently changed the clutch master cylinder (again) and clutch hose...

Hi
First post - desperate owner trying to get van ready for summer.
I have a 1988 DG 1.9 WBX (new recon engine from Campershack) and have...

Hi,
Can someone recommend a good light bar? Just had brackets delivered for a 52 inch curved light bar, there are plenty of models on amazon for...

Hi all, thanks for adding me to such a great forum!. I have recently decided to age myself by a few years and get back into T25 ownership, this time...

Hi I've just tracked down a long running oil leak a protruding nut on the exhaust manifold has worn through the above pipe on the inside out of sight...

Long time reader, first time poster here.

I'm experiencing some issues with my 1990 diesel 1.6 T3 coach and could really use some advice. Initially,...

Hi all

I know this has been covered quite a bit but I just want to clarify if it is ok to run the pierburg carb heater by splicing into the manifold...