Club 80-90 Forums

follow cable back uder hose i think it then sits in a bracket i think you pull cable up ,to give slack then then move it along in bracket .i,m not sure if thats right but give it ago!

oky coky ,,who can help with this one? i,m putting in a audi 2.2 5 pot ,old quatro engine ,it,s in gearing there but clutch no.on dropping tranny back out to check out what i done wrong looks right however ,im using t25 diesel bell housing plus adapter plate,i,m led to believe this set up was in a d...

do you have an oldskool cassette player fitted?you can get an adappter which is bassicly a cassette with a wire coming of you can plug your ipod into that your head reads that .otherwise set up a secondry system out of sight ,you can get cheep stuff at hellfrauds . good luck.

drop links ? i mean if you gentle youll never know but give it welly ,,,plus cos they hang not spottable get under with rubber mallet and smack everything.good luck.

erm i wouldnt know but why areyou changhing it ? got a free bottle off freecycle? but i,d suppose drain flush would be ok but i dont know ,bump

short bit of hose insert bolt with sealent attach jubilee if you cant get proper blanking bit.thats how mine is.

mine (1.9 dg wbx) would sit at about a millimeter left of led in normal driving condition ,traffic jam after a run it would go up then at about 3/4 mark fan would kick in .fan is quiet compared to road noise best way to no if its working leave it run till temp goes up if no forward air hitting rad t...

try the wiki fella,good luck

could be filla neck itself they rot i think only once did i fill mine up dripped loads out never gone over 3/4 since been fine (needs looking at but so does other stuff). oh and whs^^^

where now fella? uk? stop smoking update location bless you ,nice picture made van look quick,,,,must be special effects lol,,

and i thought me bird was erm plump

before setting check them bledding rod things in tubes easy to think they are right but they will put everything out if not sat in proper i had probs with timing all due to this use a toch if need be after a good look you will see if any are out, like a target,then losen all start again per wiki/hay...

hmmm mine being a water pumper running sweet ,,then ohhh then oohh again like i hit a wall then bang and steam,smoke ,kids screaming were on fire .i no longer have drive am coasting ,,piston through main casing big hole bits of metal everywhere anyway i,ve found most of bits am gunna glue it back to...

you might get lucky ,ma be gasket change allround ,could just be bottom liner seals rubber band at bottom of piston liner these can be pidley easy or not but yeah wait for someone to look at the poor girl (start saving incase)

like this?