Hi everyone.
My fan switch is foobarred! I have another one off the other van that I can swap it to but unfortunately the one off the other van is 3 pin and the one on this van is 2 pin. I assume the 3 pin one is for a 2 speed fan, is it possible to use the 3 pin one on my current van? If so which pins need to be connected?
Thanks in advance,
Jamie
Fan Switch
Moderators: User administrators, Moderators
-
jammcd649
- Registered user
- Posts: 49
- Joined: 16 Aug 2006, 21:35
- 80-90 Mem No: 2842
- Location: Nr. Bridgnorth Shropshire
Fan Switch
1986 1.9 Watercooled Camper - Diamond RV
Re: Fan Switch
jammcd649.
the diagram I have is for the '3 pin' which has.....
1. a black/red wire feed to the + pin
2. a white wire from pin 1 (goes via two resistors to the fan)
3. a yellow/black wire from pin 2 (goes via only one resistor to the fan)
4. a yellow wire from pin 3 (goes direct to fan)
Mike
the diagram I have is for the '3 pin' which has.....
1. a black/red wire feed to the + pin
2. a white wire from pin 1 (goes via two resistors to the fan)
3. a yellow/black wire from pin 2 (goes via only one resistor to the fan)
4. a yellow wire from pin 3 (goes direct to fan)
Mike
'Two 'eads is better'n wun even if mine's a sheeps'
Grun
Member Number 1250
D reg 2.1 DJ autosleeper poptop
Grun
Member Number 1250
D reg 2.1 DJ autosleeper poptop
