Clutch master cylinder replacement.

[davegsm82]

Is it possible to replace the clutch master cylinder without removing the whole pedal box?

If so, how?

Thanks.

[Lclarkk]

Yep.
Pull off line that feeds it from the reservoir
Remove hard line that exits it, either hard plastic one or solid metal one..
Two 13mm bolts
Job done !

[davegsm82]

Brilliant.

I'm guessing there's nothing clamped on the piston as such, just something pressing down on it which doesn't need to be disconnected?

Thanks, Dave.

[multisi]

There is a push rod that is attached to the clutch pedal that has to fit through the rubber boot of the cylinder, there is a diagram of it in the Haynes manual.

[Ant-t]

As above its pretty easy, make sure that the push rod is seated properly and be careful not to cross thread the lower fluid pipe union nut.