Welding panel seams?

[Woolf]

I've been learning how to MIG weld and have done a couple of simple repairs to my T25 and now feel brave enough to tackle the rotten rear arches!

One thing I'm concerned about though is how to weld the seams of the replacement panels? Should they be done from inside the van? I fear that welding the seams from the outside might look messy

[Oldiebut goodie]

I would suggest you look at some of Metalmick8y's pictoral threads and see a master at work.

[jimpainter]

It all depends if your just doing the lower rear arches, or doing the full quarter panels. Either way the majority of the welding on new panels is spot welds on the insides.

[Woolf]

Thanks guys, I've found some great info searching for "Metalmick8y".

If I can get away with just replacing the arches I think I just need to weld from underneath, but if any more metal needs replacing I'll have to work out how to remove the camping interior

[meggles]

Thanks guys, I've found some great info searching for "Metalmick8y".

If I can get away with just replacing the arches I think I just need to weld from underneath, but if any more metal needs replacing I'll have to work out how to remove the camping interior

Check the WIKI. I'm sure the info's there.

[Plasticman]

if your gonna weld an arch or such on then REMOVE whatever is on the inside as you will get heat and possibly fire
mm

[meggles]

if your gonna weld an arch or such on then REMOVE whatever is on the inside as you will get heat and possibly fire
mm

Heat in an air cooled! Marvellous Actually I shouldn't ridicule a van fire. Very serious. Be careful when welding, I've only set one vehicle on fire. Mindst you it was only a Datsun Violet Still very dangerous though 'cos I was down in a pit with the car above

[Woolf]

Dammit I know you're right.

I might have gotten away with it though