AAz Turbo Vacuum hose

Post by **steviedee** » 04 Jun 2012, 13:43

I have just got a van with an AAZ engine fitted. I have discovered a vacuum hose that comes from the diapragm below the turbo but isnt attached anywhere else at the other end. Any clues as to where it should go?

Post by **Hacksawbob** » 04 Jun 2012, 13:59

yes it goes to the LDA on the pump. Here's mine yours might look different.

Post by **steviedee** » 15 Jun 2012, 11:03

thanks for that. However I already have a pipe attached to the LDA which connects to the manifold. Doe the 2 pipes tee in together?

Post by **max and caddy** » 15 Jun 2012, 21:27

Is it attached to the bolt in the center of the turbo actuator? syncro JX turbo has a vented screw for wading...could be one of those.

Post by **Hacksawbob** » 16 Jun 2012, 05:37

Sorry, inlet manifold to lda is correct. I misread your post.

Post by **steviedee** » 20 Jun 2012, 07:28

what I have got are 2 rubber pipes coming from the turbo vacuum actuator. The one closest to the actuator arm is already connected back to the turbo body itself. The other pipe (rubber hose covered with material) is long enough to reach the rocker cover area but currently isnt connected to anything. I cant see any 'free' places that it could connect to. I've checked out a haynes manual relating to the AAZ engine and its little help - basically advises you to make a note of where the pipes go should you need to remove the turbo!

Club 80-90 Forums