I recently had a new exhaust fitted at a local garage where the engine was taken out due to every existing bolt snapping off in the block from the old exhaust,these were profesionally removed.
all seemed fine i ran the bus for maybe 10 miles,then it started to 'hold back' then the ignition light came on and it died.I tried to start it again but it wouldnt go.I gave her half hour to collect her thoughts then tried again and she fired up,just got me home.this happened two more occasions,now i'm frightened to take her out.
She is now resting in the dry barn untill i can get her better.any advice would be much appreciated,i'm not that mechanically minded as i tend to loose all the skin an my knuckles when i look at spanners.I have a fully functioning kettle if anyone is in the area-Near Dunmow in Essex.Thanks to you all
