Hi guy's can i get the sump off whilst the engine stays in the van, reason is its leaking from a bad repair where the feed pipe enters so i want to det it repaired properly.
Thanks Tony
td sump
Moderators: User administrators, Moderators
Re: td sump
Hi Tone.
Yes you can remove the sump with the lump in situ, Slacken the 2 Gearbox lower bolts off, You can get up the back of the sump then, But you will need a 3/8th drive extension bar, Not much room but it does go.
Reversal same as when refitting ie Tighten Gearbox lower bolts before tightining sump bolts Do them up last.
Yes you can remove the sump with the lump in situ, Slacken the 2 Gearbox lower bolts off, You can get up the back of the sump then, But you will need a 3/8th drive extension bar, Not much room but it does go.
Reversal same as when refitting ie Tighten Gearbox lower bolts before tightining sump bolts Do them up last.
-
- Registered user
- Posts: 178
- Joined: 22 Oct 2005, 09:42
- 80-90 Mem No: 525
- Location: Preston, Lancashire. Member 525
Re: td sump
Thanks Jeff good to talk to you mate, i think i might go down the 1y route as i 'm really getting fed up of this JX, hey stick a pic of your t4 up it sounds nice.
Tony
Tony

-
- Registered user
- Posts: 189
- Joined: 21 Nov 2009, 23:53
- 80-90 Mem No: 7622
- Location: Kent Coast
Re: td sump
May as well do the repair mate, as you'll need the sump even if the engine
gets outed . . . and once you're repaired nicely its just the cost of a sump gasket
to have it back running.
gets outed . . . and once you're repaired nicely its just the cost of a sump gasket
to have it back running.
-
- Registered user
- Posts: 178
- Joined: 22 Oct 2005, 09:42
- 80-90 Mem No: 525
- Location: Preston, Lancashire. Member 525
Re: td sump
Yeah thats true mate i just need to find a good alloy welder.
Tony
Tony
- Hacksawbob
- Registered user
- Posts: 4444
- Joined: 11 Oct 2005, 07:11
- 80-90 Mem No: 1168
- Location: Lancs UK member 1168
Re: td sump
Sounds nasty, cracked? some sort of chemical/epoxy metal might do it for now maybe even semi permanent. If you take it off I found a T-bar type hex key came in handy for getting some of the sump bolts out and in esp the ones at the bell housing end. Go round in several stages to even out the pressure. Sump gasket and oil pump are crying out to be done 'while your in there'tonysbus wrote:Yeah thats true mate i just need to find a good alloy welder.
Tony
member 1168
Re: td sump
give us a bell tony liam might be able to do it at work for you
Based in the industrial north...well...manchester way