td sump

Big lumps of metals and spanners.

Moderators: User administrators, Moderators

Locked
tonysbus
Registered user
Posts: 178
Joined: 22 Oct 2005, 09:42
80-90 Mem No: 525
Location: Preston, Lancashire. Member 525

td sump

Post by tonysbus »

Hi guy's can i get the sump off whilst the engine stays in the van, reason is its leaking from a bad repair where the feed pipe enters so i want to det it repaired properly.

Thanks Tony

Grumpy Midget

Re: td sump

Post by Grumpy Midget »

Hi Tone.
Yes you can remove the sump with the lump in situ, Slacken the 2 Gearbox lower bolts off, You can get up the back of the sump then, But you will need a 3/8th drive extension bar, Not much room but it does go.
Reversal same as when refitting ie Tighten Gearbox lower bolts before tightining sump bolts Do them up last.

tonysbus
Registered user
Posts: 178
Joined: 22 Oct 2005, 09:42
80-90 Mem No: 525
Location: Preston, Lancashire. Member 525

Re: td sump

Post by tonysbus »

Thanks Jeff good to talk to you mate, i think i might go down the 1y route as i 'm really getting fed up of this JX, hey stick a pic of your t4 up it sounds nice.

Tony :ok

footstuck
Registered user
Posts: 189
Joined: 21 Nov 2009, 23:53
80-90 Mem No: 7622
Location: Kent Coast

Re: td sump

Post by footstuck »

May as well do the repair mate, as you'll need the sump even if the engine
gets outed . . . and once you're repaired nicely its just the cost of a sump gasket
to have it back running.

tonysbus
Registered user
Posts: 178
Joined: 22 Oct 2005, 09:42
80-90 Mem No: 525
Location: Preston, Lancashire. Member 525

Re: td sump

Post by tonysbus »

Yeah thats true mate i just need to find a good alloy welder.

Tony

User avatar
Hacksawbob
Registered user
Posts: 4444
Joined: 11 Oct 2005, 07:11
80-90 Mem No: 1168
Location: Lancs UK member 1168

Re: td sump

Post by Hacksawbob »

tonysbus wrote:Yeah thats true mate i just need to find a good alloy welder.

Tony
Sounds nasty, cracked? some sort of chemical/epoxy metal might do it for now maybe even semi permanent. If you take it off I found a T-bar type hex key came in handy for getting some of the sump bolts out and in esp the ones at the bell housing end. Go round in several stages to even out the pressure. Sump gasket and oil pump are crying out to be done 'while your in there'
member 1168

dazzzer1
Registered user
Posts: 431
Joined: 12 Oct 2005, 18:43

Re: td sump

Post by dazzzer1 »

give us a bell tony liam might be able to do it at work for you
Based in the industrial north...well...manchester way

Locked