rear axle stand install location

Post by **xpress** » 04 Sep 2011, 17:34

having a bad day today, feeling a bit unsure around the rear. can anyone check if this is ok to install an axle stand here? thank you as always.

Post by **Plasticman** » 04 Sep 2011, 18:33

bout as good a place as any
M

Post by **sarran1955** » 04 Sep 2011, 18:35

Hello,

That's ok

I use this cross member with a section of channel to spread the load.

Even better is to use a steel beam with packers to lift the whole rear end, then put 2 axle stands.

Don't forget to chock your front wheels, and slacken off the rear wheel nuts before jacking if you intend to remove them once on the stands

Work safely,

Cordialement,

Post by **Plasticman** » 04 Sep 2011, 18:40

Hi Monsieur
how was your jaunt round the alps
Mike

Post by **sarran1955** » 04 Sep 2011, 20:20

Hello Mick8y,

Brilliant thanks,

2400 km through 5 countries, and I didn't even have to lift the engine lid.

I'll do a proper post when time permits, but F1 Nurburgring was AWSOME,

Booking for Germany and Hungary 2012.

Cordialement,

Post by **xpress** » 04 Sep 2011, 20:30

looking forward to getting some trips in soon, that's what its all about!

Club 80-90 Forums

rear axle stand install location

rear axle stand install location

Re: rear axle stand install location

Re: rear axle stand install location

Re: rear axle stand install location

Re: rear axle stand install location

Re: rear axle stand install location