Clutch sizes?

Post by **jamesc76** » 02 Jan 2010, 18:56

Hi all the clutch on my scooby van has got covered in oil again think its the input seal into the gear box again (havent looked yet!) So need to get a new cluctch kit again, now hears my problem the one thats on it aint that old probs about 15000 mile old so the pressure plate should still be fine after a blooming good clean! so whats sizes of friction plate are out there??? thinking of getting the biggest i can in there!

Post by **armyphil** » 02 Jan 2010, 19:54

I would have thought a disel one I think they are 228mm?

Post by **bigherb** » 02 Jan 2010, 20:22

The same size as the pressure plate.

Post by **jamesc76** » 02 Jan 2010, 21:10

Need to take it apart to get the measurement's of what size I have as its a special adapted flywheel to fit to the subaru crankshaft, its then made to fit a uprated vw clutch set up! So I need to know whats sizes are acually available !

Post by **jamesc76** » 03 Jan 2010, 16:04

bump

Website · Post by **CovKid** » 03 Jan 2010, 16:14

Look on GSF site under clutches for T25s - lists all the sizes but think you'll need to drop gearbox and get your tape measure out.

Post by **jamesc76** » 04 Jan 2010, 17:52

Cheers for that Have to have a look see once its out !

Post by **Ian Hulley** » 04 Jan 2010, 18:25

Odds are it's a 228mm James old bean

Ian

Post by **jamesc76** » 04 Jan 2010, 20:01

Ian Hulley wrote:Odds are it's a 228mm James old bean

Ian

Im sure its 210mm uprated one mate special order, thats why I want to see what I can get in it !

Post by **bigherb** » 04 Jan 2010, 21:03

jamesc76 wrote:it aint that old probs about 15000 mile old so the pressure plate should still be fine after a blooming good clean! so whats sizes of friction plate are out there??? thinking of getting the biggest i can in there!

If your using the same pressure plate you need to fit the same size centre plate otherwise you will have less friction material in contact with the pressure plate.

Post by **jamesc76** » 04 Jan 2010, 21:16

Not if I fit bigger!

Post by **toomanytoys** » 04 Jan 2010, 21:31

If the bellhousing seal is leaking (and you say again) then the input shaft can be quite in line and wearing it.. its prob also worn the oil thrower thats in the bellhousing too which wont help the seal and this isnt replacable only with a complete new bellhousing..

WBX clutchs are 215 (DF some early and 228mm.. I thought D/TD was only 215 though...
Aircooled 2L CU is same 228mm (1.6 CT is 215)

IIRC type 4 (411/412) had a 210mm clutch so its poss its one of them..

Post by **jamesc76** » 05 Jan 2010, 12:52

I think it was a cheap seal that i got the last time, so hopefully not worn f it is I have a plan up my sleave!

Club 80-90 Forums

Clutch sizes?

Clutch sizes?

Re: Clutch sizes?

Re: Clutch sizes?

Re: Clutch sizes?

Re: Clutch sizes?

Re: Clutch sizes?

Re: Clutch sizes?

Re: Clutch sizes?

Re: Clutch sizes?

Re: Clutch sizes?

Re: Clutch sizes?

Re: Clutch sizes?

Re: Clutch sizes?