Hi,
If its the speeds sensor and it fits to the back of the speedo and connects to the front loom Richard supplies (I think). There is a little blanking plate that it fits perfectly into and feeds the speed back to the ECU.
Maybe.
Jon
RJES VSS
Moderators: User administrators, Moderators
-
Jon Bisson GSY
- Registered user
- Posts: 50
- Joined: 06 Oct 2008, 18:10
- 80-90 Mem No: 6371
- Location: Guernsey
- Contact:
Re: RJES VSS
Guernsey
1982 Camper RJES Subaru
1982 Camper RJES Subaru
-
syncroandy
- Trader
- Posts: 1896
- Joined: 18 Oct 2005, 18:15
- 80-90 Mem No: 851
- Location: North Lancs. UK
- Contact:
Re: RJES VSS
My MY00 engine runs fine without a VSS signal (apart from generating a fault code). Will deffo be needed to drive the CC system though.
Syncrosport (taking a break as of summer 2024)
Volkswagen Transporter, reloaded.
252 GC5 EJ25 AAN L90D
Volkswagen Transporter, reloaded.
252 GC5 EJ25 AAN L90D
-
VWCamperfan
- Registered user
- Posts: 993
- Joined: 08 Jul 2007, 19:47
- 80-90 Mem No: 4000
- Location: Sheerness, Kent.
Re: RJES VSS
Thats just what I need for my new dash!
Wire in the black lead to permanent ground, the red lead to switched live (ignition), and the green to the VSS connection on ECU.
As said, the rear of the speedo may have a blanking plate that pops out (some havn't got this though...). Two small screws hold it in place and it picks up magnetic pulses from the mechanism in the speedo.
Hope this helps!
Wire in the black lead to permanent ground, the red lead to switched live (ignition), and the green to the VSS connection on ECU.
As said, the rear of the speedo may have a blanking plate that pops out (some havn't got this though...). Two small screws hold it in place and it picks up magnetic pulses from the mechanism in the speedo.
Hope this helps!
Mark.
I'm Not A Complete Idiot... Some Bits Are Missing!
1.6 Modified CT engine.
I'm Not A Complete Idiot... Some Bits Are Missing!
1.6 Modified CT engine.
