still got webasto problems!! last call for help!!

Post by **DiscoDave** » 26 Feb 2006, 13:36

had it working last night! was going for half an hour! didn't have it fitted just had it loose on the floor. turned it off! went to it this morning to re fit and tried it again! nothing! no fan or anything! becoming very bored with this might give up and go propex!!!

Post by **Mocki** » 26 Feb 2006, 23:01

then it is defoo a bad connection...........do you know a electrician who could look at it for you?

Post by **DiscoDave** » 27 Feb 2006, 07:22

i have decided to disect it as all the outside connections are excellent! if that don't work im going to get propex!!!

Post by **DiscoDave** » 27 Feb 2006, 20:24

last call for help!! i turn it on the glow plug relay clicks, after a minute or so the relay goes off, nowt happens!! this is really annoying me now! especially as it was working on saturday!!!

Post by **T'Onion** » 27 Feb 2006, 21:49

Is the glow- plug getting hot ?

Post by **DiscoDave** » 27 Feb 2006, 22:08

Post by **Mocki** » 27 Feb 2006, 23:19

Dave, under what situation was it working that it is not now?
Give us a few more clues, is the brain contacting properly, are the temp sensors giving the correct reading with the ohm meter?

Post by **DiscoDave** » 28 Feb 2006, 07:15

it was working sat in the footwell of the van, i had a cable tie round the thing to hold the fuel cut out switch and the main plug in contact, other than that the connections have not changed, the glow plug is new and the sensors are all reading correct! i think it might be the brain, i have treiad a different wiring loom, and a different heater and combinations of the two to no avail, they just do the same thing- nowt!

Post by **T'Onion** » 28 Feb 2006, 07:48

It does sound like the brain Dave , had you had it out of the van and in the warmth of your house on Saturday ? or knocked it about in the van ?, is it like the ebber ones in a little silver tin case ?

Post by **DiscoDave** » 28 Feb 2006, 18:34

hadn't had it in the house!! may have knocked it about a bit tho! it is a little shiny tin box with all the connectors on the frunt! one that you can't get in to!!!

Post by **mike the van** » 28 Feb 2006, 22:01

Mine did the same first off got it running outside the van lying on the ground, then installed it all nicely and the ****** won't work. I had a look inside the brain, it has a sealant that holds the innards inside and two crimps either side, if the same as mine. Battery charge needs to be good then i went through the connector cleaning and tightening.

Mike
1491

Post by **T'Onion** » 01 Mar 2006, 07:22

Dave cut into the box mate , thas got nowt to loose in doing it, clean it up and see if these out out of place,

Post by **mike the van** » 01 Mar 2006, 13:10

Cut the bond between the sealant with a old hacksaw blade between the black plastic connector block and the ally casing then just use a wide screwdriver to gently ease the plastic out of the ally tin and then you can see it in all its glory.

Mike

Post by **DiscoDave** » 03 Mar 2006, 07:23

i shal be having a go at that today!!!

Club 80-90 Forums

still got webasto problems!! last call for help!!

still got webasto problems!! last call for help!!

Webasto troubles

webasto problems