Squeaking driving us nuts
Moderators: User administrators, Moderators
-
- Registered user
- Posts: 22
- Joined: 05 Nov 2005, 13:19
- 80-90 Mem No: 1563
- Location: Chatham Kent
Squeaking driving us nuts
Hi all
Had the bus a couple of years now and in that time the bus always squeaked a little over bumpy uneven surfaces, I assumed if it was serious that the fault would be picked up in the MOT but it never was.
Now the squeaking has got really bad and only stops on dead flat surfaces of which there aren't many round here, there's no grinding, banging, pulling or anything, just this infernal squeaking when the bus bounces up and down.
Does anyone know which bit of the suspension/steering system needs replacing, funds are a little low at present so could really do with getting it right first go.
Many thanks
Brian.
P.S. it's basically a 89 converted panel van.
Had the bus a couple of years now and in that time the bus always squeaked a little over bumpy uneven surfaces, I assumed if it was serious that the fault would be picked up in the MOT but it never was.
Now the squeaking has got really bad and only stops on dead flat surfaces of which there aren't many round here, there's no grinding, banging, pulling or anything, just this infernal squeaking when the bus bounces up and down.
Does anyone know which bit of the suspension/steering system needs replacing, funds are a little low at present so could really do with getting it right first go.
Many thanks
Brian.
P.S. it's basically a 89 converted panel van.
-
- Registered user
- Posts: 22
- Joined: 05 Nov 2005, 13:19
- 80-90 Mem No: 1563
- Location: Chatham Kent
kevtherev wrote:upper wishbone bush I think
check this out
http://archive.club8090.co.uk/viewtopic ... 29&start=0
Many thanks for a speedy reply and link

I'll give that a try tomorrow [well it won't cost nowt to try

My ears still ache from that squeaking today, think I'll adjust the spare wheel position as that has been moved recently [puncture


Cheers.
Brian
- Tex Ritter
- Registered user
- Posts: 436
- Joined: 10 Oct 2005, 09:14
- 80-90 Mem No: 1057
- Location: Northumberland.
I had a squeak from my van which turned out to be the 'cone' rubbers on the front tie bars. I slackened off the rubbers enough to smear the parts of them that contact the brackets and behind the washers with 'rubber grease' ( measure the length of the thread sticking through each side front - you don't need to touch the back nuts - so you can refit without mucking up any settings)...sorted!
I think a silicone grease would do just as well. Just be sure the grease will not adversely affect the rubbers though.
Tex Ritter
I think a silicone grease would do just as well. Just be sure the grease will not adversely affect the rubbers though.

Tex Ritter
If you never have a route planned ...how can you ever be lost?
- Nicola&Tony
- Registered user
- Posts: 2674
- Joined: 01 Nov 2006, 18:18
- 80-90 Mem No: 3095
- Location: Wallsend, Tyne & Wear
Re: Squeaking driving us nuts
brianjbox wrote:there's no grinding, banging, pulling or anything, just this infernal squeaking when the bus bounces up and down.
Just wondering how you got on with fixing this Brian because we've got one of those! Did you manage to fix it and if so, was it a difficult job?
Cheers

Tony
Looking for: window apertures for side windows, at the back of the van
T25; 1985; RHD; 1.9DG petrol / LPG; white Autosleeper high-top; Looking rusty again!
LT31; 1993; RHD; 2.4L petrol; high-top; diy camper project.
T25; 1985; RHD; 1.9DG petrol / LPG; white Autosleeper high-top; Looking rusty again!
LT31; 1993; RHD; 2.4L petrol; high-top; diy camper project.
- Nicola&Tony
- Registered user
- Posts: 2674
- Joined: 01 Nov 2006, 18:18
- 80-90 Mem No: 3095
- Location: Wallsend, Tyne & Wear
Oops! I should've read all of the linked post before posting that!
Grinding and welding . . . will have to wait until we can afford to ask a garage to do that!
Tony

Tony
Looking for: window apertures for side windows, at the back of the van
T25; 1985; RHD; 1.9DG petrol / LPG; white Autosleeper high-top; Looking rusty again!
LT31; 1993; RHD; 2.4L petrol; high-top; diy camper project.
T25; 1985; RHD; 1.9DG petrol / LPG; white Autosleeper high-top; Looking rusty again!
LT31; 1993; RHD; 2.4L petrol; high-top; diy camper project.
-
- Registered user
- Posts: 27
- Joined: 22 Feb 2007, 11:15
- 80-90 Mem No: 0
- Location: bedfordshire
-
- Registered user
- Posts: 115
- Joined: 20 Oct 2005, 19:45
- 80-90 Mem No: 1225
- Location: Gnosall Stafford
Front inside wishbone bushes
The squeaking will probably be the inside top wishbone buses if it appears to be coming from under the front seats.
Mine did it after replacing them! I sprayed some silicone lubricant on them and the noise went away. Comes back a bit in very dry weather, no problems this year!
Check to see if there is any play in these bushes before you go ahead and replace them.
Mine did it after replacing them! I sprayed some silicone lubricant on them and the noise went away. Comes back a bit in very dry weather, no problems this year!
Check to see if there is any play in these bushes before you go ahead and replace them.
Trundletruc 1984 DG-DJ Devon Moonraker