Club 80-90 Forums

hi guys doing the rear trailing arm bushes but having trouble removing the rear hub nut any ideas much appreciated as need to get sorted asap cheers marc

hi can any one please tell me who on here sell the small metal blocks that are part of the gear stick mechanisum to do with gear selection cheers marc

hi ive purchased led replacement dash lights from camper van culture they work fine on the bench but just cant get them to work in the van I no they are polarity sensitive but have tried them both ways around any ideas cheers marc

hi recently my speado needle has started bouncing up and down making it hard to read the speed anyone any ideads whats causing it and how to fit it cheers marc

what sealer is best to use in the bodywork seams before painting cheers

hi has any one fitted an ahu into a 1.6cs engine bus if so is it an easy swap wiring etc & can u use manifolds & turbo that come with the engine cheers

Hi has anyone fitted a alf engine from a polo im led to believe its the same as a 1y

hi has anyone done a crankshaft oil seal cambelt end on a 1.6 diesel is it a difficult job / big strip down cheers marc

does anyone have any suggestions how to hold crank on a 1.6 d at tdc as every time I go to tension up belt it always seams to move slightly. is there anyway to lock it into place

hi changing the head on my 1.6 diesel n/a I no how to lock the cam off need to no the flywheel timing mark & which hole in the pump pulley to put the pin in & is the pump pulley on a key way of some sort so it can only go on the pump one way any help much appreciated

hi does anyone no where I can get a water pipe flange that goes on the end of the head with the glow plug temp sender in 1.6d cheers

hi all me again new head fitted all timed up right or so I think but she wont fire up can someone let me no the exact timing marks so I can double check & theres 2 holes in the pump pulley for the pin how do you no which one to use it seams like its a diesel problem any ideas cheers marc

no problem cam all locked with bar at the rear cheers

hi just removed my cam pulley & noticed a slot in the cam for whats looks like a key of sum sort on there was nothing in mine so was wondering if there should be or does it just tighten onto the taper

cheers new head due this evening or tomorrow so will be straight on it cant wait to get the single cab back on the road