Club 80-90 Forums

Sleeving 

Thank you. I will keep trying to find this issue. Iam not sure how that tap works to be honest,it’s got a 12v feed to it all the time from the wiring loom at the back of the cupboards which is in black protective sleeping.Then on top of the water tank where my pump is connected to a orange cable I s...

Hi all. I wonder if any one can help me on my sink tap which is very intermittent. sometimes it works straight away when you turn it and you hear a click,sometimes it takes a while before pump engages into action.Checked block connectors and there’s power to tap but sometimes the power doesn’t get t...

A up .
yes I think you will be okay as long as you do regular oil changes .

Hello there. I’ve got a oil cooler from Brickwerks fitted to my TD AAZ engine. when I change the oil  on my camper I drain the oil ,then I undo the top oil cooler pipe at the oil cooler thermostat where the oil filter screws too then I get my compressor pipe to fit into this and blow air into the pi...

Hi there.
Ive used a lump hammer and sharp chisel before on the edge anti clock wise hit should shock it moving.
good luck.Dazzer.

Hi there.
Just done this job myself.
I would think all the weight is on the eccentric washes.
Make sure the top wishbone bushes have been spot welded after being pressed in.
Make sure the long through bolt is tight.
Hope you solve it.Good luck.

Hi There. Ive just done this job and put the steering knuckle in a vice.Then heated the steering knuckle up slowly around bottom ball joint not to much. Then I got a socket that fitted on the bottom and hit it with a lump hammer.It moved slightly then shot out. It was tough getting it out so I decid...

Thank you for your help.

Hi everyone. Ive just replaced the front end top wishbone bushes and inner rubber bushes and top and lower ball joints on my T25 Westfalia campervan. Could anyone advise me where to go in nottingham for setting up and alignment of the front end. Thank you in advance.I went to vw but there machine is...

Hi People. I took my Westfalia pop up bar mechanism off this weekend and fixed it.The Horizontal bar had worn through on both sides(not very thick steel tube). I got some thicker steel tube,but smaller diameter  and pushed that into existing horizontal bar at both ends pass the nut&bolt hole.Dri...

Hi There. Just to let everyone know I changed the relay on the A pillar above my bullet fuses(the small one) and now I have both speeds on my radiator fan.It was difficult to get to because of all my old wires which over time have stiffened up plus dash board in the way.But now all good ,thank you f...

Hi. Yes my AAZ is the same with the early opening thermostat and oil cooler at the front from Brickwerks but last summer when it was hot outside the temperature gauge went really high when I was stuck in a jam for half hour. Then last week in the MOT for 45 mins on tick over ,when I returned to the ...

Hi Aidan.
Thank you for your help.
I’ve ordered some relays from Brickwerks and will let you know what I find.
Cheers

Hi There everyone. I wonder if someone can me work out why my fan only works on low speed when I bridge the wires on the temperature sensor switch which is two speed.No power on high speed at electrical switch 3pin plug. My van is a diesel and went to MOT last week and after 45 mins still no fan kic...