Anyone got a wiring diagram for a zig cf-6?

Post by **futurecut** » 26 Jun 2006, 22:16

I can maybe work it out, i haven't tried yet. The confusing factor is that it's got a wee plastic socket with a wee plug that fits into it (about 1 inch square) which looks to me like some type of security device or something you can remove to shutoff the leccy so the kids don't fry themselves? That wot it is?

Plus it's from a danbury with an electric roof that i'll be re-fitting to a new bus so a diagram of the rear terminals would be good. It's different to the cf8 on the wiki.

Other thing is that it's got lengths of bare wire like fuse wire that come out of a couple of holes on the back which dausy chain some of the terminal blocks together? Wots that all about then?

Thank you boys and girls.

Post by **OLD ONE** » 27 Jun 2006, 10:52

Hi ...Try going on line to ZIG. Had same probs myself when I purchased a secondhand unit, got details from them. Good luck.

Post by **futurecut** » 29 Jun 2006, 18:31

Well done to zig, sent an e-mail and they responded next day. Seems cf6 is same as cf8 at the back which i worked out after i noticed the wiki manual had a wiring schematic. Doh!

Post by **Hacksawbob** » 29 Jun 2006, 19:08

Seems cf6 is same as cf8

I'll add that

Post by **rugchucker** » 30 Jun 2006, 18:41

Hi
I dont suppose you could e mail me the details? I have been trying to figure it out too.

My email address is des4dubs@aol.com

Post by **futurecut** » 02 Jul 2006, 11:46

There's a link to the pdf in the wiki old boy...