WBX fuel pump clamps.

[Simon Baxter]

Just landed while I was off at vanfest, will be on shop later this week.
2 pieces, upper and lower, Stainless steel.

Cant decide if they should be a complete kit with rubber bobbins and nuts and washers etc, or just the bare clamp?

[Pickles]

Another top product from the Baxter .

Ps.
What are the advantages over cable ties, that I am using at the moment.

[Aidan]

bobbins are always shot and cable tied together

[Justavan]

I'll Second that Aidan as my fuel pump is also cable tied with a ring of rust stuck round it so a full kit ready to fit would be the requirement for me.............

[Mercdoctor]

And me.....

[HarryMann]

.. and keep checking pump body for bad corrosion and sort if so, maybe rare, but can leak badly

[Simon Baxter]

And will probably be worse with stainless against ally.
They will need insulating to stop electrolysis.
Most aftermarket pumps now are much slimmer, with a rubber sleeve to take up the "girth"

[Simon Baxter]

<< Clicky >>

[KarlT]

Site down,. Are you selling the 'rubber bobbins ' seperately?
Are they as per original ones?

[Simon Baxter]

Just updating the webshop.
Bobbins are JX air box mounts, little bit shorter but loads more robust (with them being from a Diesel, of course)