Stainless exhaust for SA / 5-pot anyone?

[silverbullet]

I'm going to go and have a chat with a local stainless exhaust manufacturer today (Weds). They are called Cheesman Products and have been in business since 1973.
I'm after a quote for a direct replacement performance stainless system to fit all 5 cylinder SA T3's, so I'm taking the 2.6 over for them to have a look on the ramp and they will work to the original system as a pattern. As far as I know, all the 2.5, 2.3i and 2.6i motors use the same exhaust.
I plan to do away with the restrictive "double-back" centre box and replace it with a straight-through box with a 180 bend and then have a double tailpipe on the rear box.
There may be an option to make a 5 branch manifold too, but that will bring the question of whether to go for a pukka 5-into-1 and do away with the double down pipe, or stick with the 5-into-2 and have a flange joint so it will fit buses with the standard iron manifold.
If I can raise an order for a batch of 5 systems, the unit cost will be far more reasonable.
What do you think? Interested? NOTE these will be genuine lifetime guarantee systems.
Reply here if you're in.

also on brickyard

UPDATE Getting a price for a system from the downpipe flange (using standard iron manifold) with round straight-through boxes (cheaper than ovals). Tailpipe tbc. Should be a day or so.

[silverbullet]

Got the quote on this morning...for a one-off system only (no manifold) £1500 and if it was 5-off, £930 each and I'd be doing it for glory...They're having a Turkish. The work there is nice, but I think they're trying to say they don't want the hassle of such a small quantity.
Longlife is is then