R & R bed Q,s.......

[RODEO]

Hi All ,Im a newb ,so first post.......and be gentle!
Ive owned/converted several vans over many years ,mostly with radical mods and engine swaps etc. ,but never owned a T3,but thats all about to change in the next two weeks...anyway to the plot......The van has a R&R bed fitted,and Im not sure how it folds out to form a bed,and what position in the vehicle it ends up in .Can the beds (in seat mode) be used to sit on ala a normal seat when travelling? If so ,are there seat belt anchorages on the pillars between the windows(mines a m/bus twin slider.)
Thanks
Regards........

[toolsntat]

Bit of good belt reading here.... https://club8090.co.uk/forum/viewtopic.p ... 4&start=15" onclick="window.open(this.href);return false;

And welcome

Andy

[RODEO]

Had a read of that,thank you.I think I may remove the R&R bed after looking at a few pics and realising the 'mattress' relies on the cushions pushed together. Ive had lots of probs with this type of mattress set up over the years ,and prefer a continuous mattress with no potential gaps.I doubt whether we will use the sleeping area much (only to christen it, fnar fnar!)So I think I will get hold of a lump of foam to form the mattress from,just to keep SWMBO happy!
Rod