indicators

[odin]

when i put my indicators on the green warning light comes on put no indicators any help

[kevtherev]

put no indicators

have you got a cold?

fuse
Bulbs
relay

any of those three
my guess is the relay if it don't tick, tick, tick

[Gunslinger]

could be bad earth. I had similar fault and was bad earth. My earthing point is on the passenger A pillar behing the glovebox, not sure if thats the same with all T25's

[odin]

i can not get my indicaters working i have tried all sugestions does any one know a electrician in coventry area that could help please

[CovKid]

Odin, when the warning light comes on, does it stay on or flash?

[kevtherev]

i can not get my indicaters working i have tried all sugestions does any one know a electrician in coventry area that could help please

OK so tell us ....we assumed you checked that there is power at the switch, and the fuse was checked, along with the earths.

[Cafnod]

Have you checked your fuse? It is number 19 in a blade type fuse box.
The earth point on my van is a bolt to the bulkhead under the right hand side of the dash, visible when looking up from the pedal box area.
Do your hazard lights work?
An indicator relay is not expensive, but ackward to test without right gear, I would check the fuse, earth, switch and relay in that order.
I do not know an AE in coventry. I am in worcester from tomorrow midmorning until Friday morning and will have equipment as I am doing wiring on a friends narrowboat.
I realise you might not want to drive vehicle with no indicators.
07968 599882 if I can be of help.

Richard

[odin]

green light stays on but when i touch grn black and white wire on plug toindicater switch with a skrewdriver with light in it and lead to earth light in screwdriver flashes emergenseylights work normal

[CovKid]

PM me Be useful if I knew how far away you are

[Cafnod]

green light stays on but when i touch grn black and white wire on plug toindicater switch with a skrewdriver with light in it and lead to earth light in screwdriver flashes emergenseylights work normal

If I understand correctly what you are saying is that if you touch the test lamp probe to the relay fed feed to the indicator switch the test lamp flashes.
In that case the power is getting to the switch and is being interrupted correctly by the flasher relay.
Therefore you have a faulty indicator switch.
Never had one of these apart on a T25 BUT I would suggest it is the switch contacts that are dirty OR the connection where the live feed goes to the switch is the problem.
Easily fixed, hopefully by removing the cover and using WD40 (disconnect battery earth first) another good contact cleaning agent is isopropyl alcohol, used on a cotton bud.
Hope this helps, it should be the case that the worst possible scenario is a indicator switch.

[CovKid]

He's a bit busy at the moment but said I'll drop in and take a look. The Covkid and Chickenkoop flying squad!