gear box and linkage

[jexps]

Dear club80-90 brothers and sisters

My t25 1987 water cooled 1.9 ltr campervan is giving me a head ache. I recently replaced my gear box and as far as i can tell i did a good job, as when it was on axle stands all the gears engaged, with engine on, but now i have taken off axle stands i am unable to engage any gears.I was wondering if i had made an error with the linkage. any advise would be appreciated.I have looked at the haynes manual but it really doesn't help.

jode

[T'Onion]

sounds like you need to extend the linkage a wee bit , thinking about it as the rear is up in the air the linkage would be shorter , only by a cm or so

mark it all up and then loosen the linkage coupling , pull it out a cm ,and then try it