temperature gauge

Post by **behai** » 13 Jul 2008, 07:56

As soon as I turn the key in the ignition the temperature light and needle goes straight up. Can anyone help?????? Forgot to say it is a 1.9 wasser boxer engine........

Post by **Grun** » 13 Jul 2008, 08:26

A short to earth in the wire (yellow/red) from the gauge to the temperature sensor, (or a faulty sensor causing a short circuit) would have the same effect I think.

Sensor (sender) is fitted into the plastic thermostat housing of a 2.1 not sure of 1.9.

Plenty of posts on this type of fault.......... have a trawl...... and look in the wiki (top of page)

Mike

Post by **kevtherev** » 13 Jul 2008, 11:04

indeed ..take a look.

disconnect the sender (top of the expansion tank)... does it do it now?

Post by **Mocki** » 13 Jul 2008, 22:16

kevtherev wrote:indeed ..take a look.

disconnect the sender (top of the expansion tank)... does it do it now?

nope! this is the low coolant level part of the system, not high temp, it is not signalling to the gauge, only the warning light......

id say either the temp gauge sender in the thermostat housing, or a short in the wire to earth ( melted near zorst possible) or crud in the plugs in the wiring

Club 80-90 Forums

temperature gauge

temperature gauge

Re: temperature gauge