Getting alloys machined to fit

Post by **tobzman** » 01 Feb 2006, 13:10

I've just picked up a set of audi A6 rims for my van and I need to get the centre bores machined out to fit. Has anybody had this done and what sort of place have you approached for the job? I'm in the cambridge area so if anybody knows of anywhere local to me that would be great.

Cheers
Toby

Post by **TechtroT25** » 01 Feb 2006, 13:22

Have a word with a local engineering shope they will probably be able to do it

Post by **Highland John** » 01 Feb 2006, 19:24

My mechanic mate did mine with a power drill and a burr bit . Took a while , the burr kept clogging , but cost nowt

Post by **lone gunman** » 01 Feb 2006, 19:29

Ask your local garage where they get heads skimmed etc and try there.