front to rear clutch pipe.(where from)

Post by **BLUG** » 24 Feb 2008, 15:53

its 1/4 inch pipe, i have loads of 5mm, (or 3/16) but i can find this stuff anywhere, im also after some male/female unions.gonna make it myself btw.

anyone??

Post by **Westy.Club.Joker** » 24 Feb 2008, 16:27

Try Baxter at Brickwerks, sure he`s got some in his online shop.

Post by **BLUG** » 24 Feb 2008, 16:58

just had a look on, and cant seem to find it, he has the syncro short one , and the slave cylinder one,gonna try a last resort tomorrow.

Post by **skell** » 25 Feb 2008, 13:43

I found 1/4 pipe in my local motor factors, haven't yet managed to find connectors, but have been distracted with other things

Post by **skell** » 25 Feb 2008, 13:46

should have said if you can't find any I've got more than I need, will post to you at cost + post (whole coil was about £30), the pipe I have is kunifer.

Post by **Ian Hulley** » 25 Feb 2008, 14:19

Try looking for 'Hydraulic Hose Manufacturer' or similar in your Yellow Pages. We have a local company who service the Commercial Automotive industry round here and they do all the sizes of kunifer, braided hose and relevant fittings .... there'll be one in most areas .... you could try Pirtek for starters

Ian.

Post by **BLUG** » 25 Feb 2008, 20:21

i managed to get some copper pipe today from maccess, ive heard about pirtek, but the impression i cos was that they only do flexis,i found a company just up the road from work, who might be able to help out, im gonna give them a try tomorrow,.