Probably a stupid question but what exactly is the purpose of a relay?
Sven
Relays
Moderators: User administrators, Moderators
-
- Registered user
- Posts: 119
- Joined: 11 Oct 2005, 08:34
- 80-90 Mem No: 997
- Location: Preston, Lancs
Relays
Feeling like a freak on a leash
no. 997
svenlivesey@hotmail.com[img::]http://i126.photobucket.com/albums/p102 ... /flat4.jpg[/img]
no. 997
svenlivesey@hotmail.com[img::]http://i126.photobucket.com/albums/p102 ... /flat4.jpg[/img]
-
- Trader
- Posts: 836
- Joined: 11 Oct 2005, 06:36
- 80-90 Mem No: 1315
- Location: deepest devon
- Titus A Duxass
- Registered user
- Posts: 5778
- Joined: 24 Nov 2007, 08:22
- 80-90 Mem No: 4475
- Location: Cologne
A relay allows the switching of high current without loading the switch itself.
If you measure the current flow when you e.g. toot a set of horns you should get somewhere around 7 - 9 amps. This is okay through your switch gear (horn button) but only for a very short time. If you were to toot your horn for say 10 minutes your switch gear would get very hot because of the current flow, which could cause damage and more importantly the switch itself will limit the current flow to the horn.
By using the horn button to switch a relay on (to energise) you channel the high current flow through the relay contacts (which are normally around 30 amps.) instead of the horn button. This equals less heat for your switch and more horn! (ooe'r missus!).
If you measure the current flow when you e.g. toot a set of horns you should get somewhere around 7 - 9 amps. This is okay through your switch gear (horn button) but only for a very short time. If you were to toot your horn for say 10 minutes your switch gear would get very hot because of the current flow, which could cause damage and more importantly the switch itself will limit the current flow to the horn.
By using the horn button to switch a relay on (to energise) you channel the high current flow through the relay contacts (which are normally around 30 amps.) instead of the horn button. This equals less heat for your switch and more horn! (ooe'r missus!).
thats a good description if you think of a starter motor in the same way you switch a low current coil with a very thin wire which in turn bridges the 2 massive teminals which turn your engine thru the fat red wire. the coil you energise at low current is actually a powerful electro magnet once energised, which pulls magnetically the 2 contacts together for high current (thats the click you hear from either a relay or a starter motor)Titus A Duxass wrote:A relay allows the switching of high current without loading the switch itself.
If you measure the current flow when you e.g. toot a set of horns you should get somewhere around 7 - 9 amps. This is okay through your switch gear (horn button) but only for a very short time. If you were to toot your horn for say 10 minutes your switch gear would get very hot because of the current flow, which could cause damage and more importantly the switch itself will limit the current flow to the horn.
By using the horn button to switch a relay on (to energise) you channel the high current flow through the relay contacts (which are normally around 30 amps.) instead of the horn button. This equals less heat for your switch and more horn! (ooe'r missus!).
you could do without them if you were prepared to use the massive clunk switches you see in the old frankenstein movies
LT owner and positively rattling around with the new found space
member 3339
member 3339