in the following image, should the mounting point at the rear (C) be threaded or just a hole?
all of the other mounting points are threaded in my kombi but not this one...
am i supposed to simple nut and bolt the inertia reel through the hole?
the metal looks a bit thin...
I used JK fittings when I fitted mine at point C - yes the metal is thin but you can bolt on side plates from the kit either side to strengthen it. (The JK kit came with a fitting sheet - I'll try to find it and scan it in).
VW Fan Learned to drive in a T2, then drove a T1, later a T4, then a T5 (and a few Audis and Passats)
Now a proud T3 Caravelle GL 2.1 DJ WBX owner: "Dora the Explorer" .. by my reckoning, a T15 Driver! Dr T15 Speaks!
in the following image, should the mounting point at the rear (C) be threaded or just a hole?
all of the other mounting points are threaded in my kombi but not this one...
am i supposed to simple nut and bolt the inertia reel through the hole?
the metal looks a bit thin...
cheers, shapey.
C is 2 (or 3?) 8mm holes.
Bolted into the two holes is a T shaped bracket that then holds the seatbelt reel by means of a 7/16's UNF bolt.
