Fitting alloys to Type 25

[nesty]

Hi

I got a set of Audi alloys for my type 25. To get them to fit safely. I know I'll have to lengthen the studs for the rear.

Though how do I get them to go over the bearing housing at the front. I suppose I'll have to ream the centres of alloys out.Any advice on how to do this?

thanks

Nesty

[R0B]

where are you.fill your profile in.someone in your area may know an engineers who might do them for you.you may need spacers as well.and longer studs/bolts on the fronts...

[vic20]

Hi

I got a set of Audi alloys for my type 25. To get them to fit safely. I know I'll have to lengthen the studs for the rear.

Though how do I get them to go over the bearing housing at the front. I suppose I'll have to ream the centres of alloys out.Any advice on how to do this?

Hi

I put audi's one Bill this year. I had to replace the rear studs with longer ones, took off the brake drum and hub, pressed the old ones out and then had to use a 10 ton press to get the new ones in. Front i took to a little industrial unit where there was a metal fabricator and he bored them out for about 8 quid each.

If you're norfolk way will let you know where

[nesty]

Hi

Many thanks for the replies. I might be going to Sherringham on Friday for a break.

Nesty