rev counter question

Post by **sandcrawler** » 09 Jul 2007, 23:27

im going to fit an after market rev counter,will i have to run a wire from the coil to rev counter or is there already a wire that runs up to the instrument pod that i can pick up from ?

regards
Alister

Post by **tonytech** » 10 Jul 2007, 07:29

I think it depends on when your van was made and what its original use was. (panel van, Caravelle, etc)

Wire should be red/ white stripe I think)
T

Post by **mininut** » 10 Jul 2007, 22:12

Fitted one myself a few moths ago (piccie of it in 'garage'^).

Two wires to your coil (+ and -)
One to an earth (body)
One to your side/head light switch.

Simple as that

Post by **guz** » 11 Jul 2007, 19:15

mininuts wrote:Fitted one myself a few moths ago (piccie of it in 'garage'^).

Two wires to your coil (+ and -)
One to an earth (body)
One to your side/head light switch.

Simple as that

i've only got one wire to my coil
and it works fine.

wire it to the right part of the
switch and illumination dimmer
should work too.