Glove box Repair

[mioba]

So after years of being fed up with the glovebox dropping down and the contents falling over the floor I decided to repair it.

The two retaining latches as you know snap.

Yes the latches that you need to bend inwards to drop the glovebox.

The latches themselves are a replaceable part and had the original VW part numbers 251857159 & 251857160.

There is never a need to replace a good glovebox if the latches are snapped.

The old latches are glued onto the insides of the glovebox and a thin strong screw driver between the latch and glove box gets them off, aided by the blows of a hammer.

I have seen the likes of SHC do the latches. But with all respect the price is a tad high for what they are.

So a search online found the 3D print file.

https://www.thingiverse.com/thing:5044172

So off to a local 3D printer who made them from ABS plastic for the princely sum of 3 pounds each. They are spot on.

Back home 3 dobs of araldite glue in the same place as the originals, clamped then and a couple of pop rivets for good measure.

The glovebox is happy and so am I.

Now there is also a strap. One end of the strap hooks on the back of the glovebox and the other end sits in a recess in the metal work at the back of the glovebox. I assume VW added this to allow lowering the glovebox without it tipping fully to gain access at the back.

Again I had this 3D printed included in the above price.

The file is found here:

https://www.printables.com/model/601887 ... ap/related

The strap is not essential. But ad many of us are A. Then theres your dinner.

I know we cant upload pics on the site and I am
not one for opening another account on a hosting site.

I hope the above is helpful.