Well I took off my tank breathers to replace all lines, paint the arch and general clean up.
Went to put them back on. Stumped!
How do I do it? If I put the “lump in the hole” the bolt hole is no where near lining up. If I put the bolt through the hole first, I can’t push the other end up!
What’s the correct process? Does the “shreks ear” pipe go down the corner or along the flat?
Thanks for any help!
Sent from my iPhone using Tapatalk
Tank breather - how do I get them back on!?
Moderators: User administrators, Moderators
-
T25boy71
- Registered user
- Posts: 187
- Joined: 21 Jun 2019, 20:56
- 80-90 Mem No: 16913
- Location: Weybridge
- Contact:
Re: Tank breather - how do I get them back on!?
Photos
Vw T25 1.9 TD Z1 hightop rusty but Less rusty than when I got it. lol: 
-
Plasticman
- Trader
- Posts: 8077
- Joined: 12 Oct 2005, 20:55
- 80-90 Mem No: 1948
- Location: lincolnshire
Re: Tank breather - how do I get them back on!?
If you've cleaned it all up then we apply some vaseline to the lump as you call it the bolt up but not tight trial and error once you've done you will always remember, then with the heel of your hand give it a good short sharp thump up and it will pop right in
mm
mm