When i got new bus i knew that mirrors didnt work, turns out paint shop had cut wires to get mirrors off!! What a bunch of
Anyway i have rewired them back up and still they dont work. Checked fuse, unplugged the connectors on both doors and tried all ways with a multimeter but cannot find any power coming through at all!
Anyone got any ideas what else i could check?
Electric Mirrors?
Moderators: User administrators, Moderators
Still no further forward with this. fuse is good, all wiring seems good as far as i can see.
tried looking at the back of the fuse board to see a loose connection but cant see anything! Where would they connect on here?
Just cant get them to do anything, tried all ways with a mutimeter and doesn't seem to be power through to them or swith at all!!
Any thoughts much appreciated
tried looking at the back of the fuse board to see a loose connection but cant see anything! Where would they connect on here?
Just cant get them to do anything, tried all ways with a mutimeter and doesn't seem to be power through to them or swith at all!!
Any thoughts much appreciated
-
tonytech
- Registered user
- Posts: 1194
- Joined: 11 Oct 2005, 06:40
- 80-90 Mem No: 477
- Location: Liverpool
OK.
looking at the Bentley circuit diagrammes.
The power feed is from fuse S12 via a black yellow stripe wire to the switch in the drivers door.
Ignition must be on.
Fuse S12 is supplied via the load reduction relay (as are the wipers, heater fans, lights etc)
So as a starting point apply 12v to this wire and see if any thing happens.
T
looking at the Bentley circuit diagrammes.
The power feed is from fuse S12 via a black yellow stripe wire to the switch in the drivers door.
Ignition must be on.
Fuse S12 is supplied via the load reduction relay (as are the wipers, heater fans, lights etc)
So as a starting point apply 12v to this wire and see if any thing happens.
T
There are 10 kinds of people. those who understand Binary and those who dont