Drill Q (MM)

[ELVIS]

Ladies, taking the load bed of the single cab, going to drill out each and every one of those mo fos

(System I use it to flame the paint with a blow torch, then wire brush it by hand . Just do it over the spot welds, takes seconds but leaves enough paint in the spot indents to centre perfectly )

Anyways, recommended/besterest spot weld drill bit? Tungsten carbide? What size ? 6/8mm ? Will one be enough if I run the drill at appropriate speed so I am cutting and not just spinning and overheating?

Ideas?

Mm?

[what2do]

Dormer are a quality brand.

[Plasticman]

wurth for me 8mm beg or borrow a magnetic stand makes ife easy for many of them
mm

[ELVIS]

Cobalt , tungsten carbide?

[Plasticman]

Cobalt ,there are cheaper but so.stones trial and error

mm

[Shaundon]

sorry to hijack but im also looking for one

seen these two on ebay...
http://www.ebay.co.uk/itm/WURTH-COBALT- ... 0394080366
http://www.ebay.co.uk/itm/WURTH-ZEBRA-S ... 1103192179

is it worth the extra money for the 2nd one?

[Plasticman]

I found little difference in the past same with the gold coated,no discernable difference