Cableway.......Between Front bullhead and Door

[GrahamL]

Hi,
Not sure if this should be in another section but........
I am currently putting together my van and without prior knowledge I need to know how the semi- flexible tubular housing for speaker and electric mirror cables is fastened at either end, to the front bulkhead or door.

Any assistance will be appreciated.

Regards
Graham

[lloydy]

They just push in to the pre made holes in door and bulkhead, each end is like a grommet.

[Plasticman]

assuming your door and bulkhead have cut outs for them as not all doors do
mm

[lloydy]

poverty spec vans?

[Plasticman]

hehe
https://club8090.co.uk/forum/viewtopic.p ... &start=105" onclick="window.open(this.href);return false;
mm

[GrahamL]

Hi,
Yes.....the nineteenth photo in shows the semi rigid housing, all though it emerges from the bulkhead through a square hole and will (possibly) terminate onto another square hole in the door.
Regards
Graham

[scottbott]

can they be fitted without the metal bezel/trim piece?was hoping to fit some in the new year but do not have metal parts

[GrahamL]

Hi,
Still unsure how both ends of this semi-rigid cable housing will terminate on the bulkhead or door!!!!
Regards
Graham

[Plasticman]

Read what I've said , have a look in your door ,is there a circular cut out to take the end ,same in the bulkhead , now to save us all a lot of guessing , why don't you take some pickies of the inside of your door ,also the bulkhead and also the part you have doe a joiner

[ELVIS]

Fitted them to most of my vans. They all appeared to have the holes from factory covered in what looked like a round piece of sticky paper/gaffe tape that had been over painted. Difficult to see, put if you get a finger or two in, you can often find the hole

[GrahamL]

Hi,
Please see photo's
Regards
Graham

[lloydy]

i can't really make much sense of those pics.. But here is some pics of mine.
1st pic shows it going into the door opening, and as you can see there is a hole it pushes into

2nd pic is where it comes up into the bulkhead area

[GrahamL]

Hi,
Thanks for the photo's.
Am I correct in thinking beyond the pair of square apertures there are large circular holes where the semi- flexible hosing secures too?
Oh.....
Has anyone got a pair of the following

[lloydy]

yes, round holes. you can see them clearly in my pics. If you have one of the rubber conduits, just look at the ends, its pretty obvious how they secure

[GrahamL]

Lloydy,
Thanks for your assistance....well appreciated.
I note that a rubber seal / collar is installed, I am assuming this is to the jamb?
Regards
Graham.

Oh no luck with the window bracket end pieces (pt no 21600914510-RHS)