Side panel supplier

[badgerfax]

Any Idea if tall side panel where the fridge goes is available for a LHD.

I've had a look on Heritage, Schofield & the dreaded just campers & am having trouble finding the right panel.

I seem to remember seeing a panel that goes up to the middle. The bottom of mine is shot & I have bubbles around the vents for fridge & water.

Any pointers gratefully received.

[Plasticman]

i can sort you from the lower swage down ,
i dont think there is and diff in that panal lhd/rhd
mm

[badgerfax]

Thanks mike, I'll post up a couple of pics later showing the panels I'd like to sort out.
Maybe you would be so kind as to frighten the hell out of me as what may be lurking underneath

Hoping to get the panels sorted so I can approach someone to fit them for me.

[badgerfax]

Feast yer eyes
Not so bad?


A usual suspect


Off side is the worst, Don't know whats going on here








Not sure how many panels i'll need for this. The sill below the fridge looks solid. I know the floor behind the fridge will need doing as when I took the fridge out in the summer I could see a hole. Not massive tho.

[Plasticman]

you will need a panal from lower swage down on fridge side (ive just finished one for a guy this w'end)
then lower outer sill, then a pair of inner closures.
ns B pillar , this is the usual area and usual rot, fork out a new genuine arch there are several suppliers, or remove and make a new edge which is what i often do can send a link to last one or two if you want an idea,
rear lower 1/4 normal but the inner area will be goosed and need remaking, both sides no doubt , i just chop the bottom of the rear corner of to give access and rebuild from there, the osr arch , dont look too bad certainly an arch fit as opposed to a tall panal and you would never tell , pm me if you need more info
mm