Bearing fit(loctite)?

[dave friday]

Afternoon all,the rear wheel bearing housing is worn(both sides)on my van,what bearing fit stuf have you lot used?
Ta.

[Aidan]

I use 638 generally as a good compromise of heat and tolerance, you can get stronger, you can get hotter, you get less tolerance
3ml tube will do a few pair of rears happily

[Fabzzz]

I use 638 generally as a good compromise of heat and tolerance, you can get stronger, you can get hotter, you get less tolerance
3ml tube will do a few pair of rears happily

there you go guys

http://www.loctite.co.uk/loctite-4087.h ... 000028Z%7c

[dave friday]

Thanks Aidan,just the info I need.
Fabzzz thanks to you too,I might check how out of round the bearing housing is!.

[Trundler]

My last set were put in with Wurth High Strength Bearing Retainer (http://www.wurth.co.uk/data/productdocuments/050055.pdf" onclick="window.open(this.href);return false;) but they've only just been done so I don't know yet how long they will last this time. My all time low was 2500 miles (with no bearing retainer compound)..