Help jx won't run after new flame traps installed

[bowesy]

I have replaced the flame traps and now my van wont start I have an mot booked at 4 so I'm running out of time now I torqued the injectors to the correct torque and installed the traps the right way but it won't start helppppp

[Titus A Duxass]

You'll probably need to bleed the fuel system.
A really strong battery can wind the engine over enough to bring the fuel up to the injection pump but it has to be a good battery.

My brother puts a bit of clean pipe on the fuel line and sucks the fuel up (he takes in quite a bit of washing as well).

[bowesy]

I have bled the injectors there i fuel coming out of them I have now got it to run after a lot of cranking and foot to the floor but it runs very very lumpy then cuts out I have black smoke coming out of the exhaust I used to get white before this it was running before I replaced the flame traps although it wouldn't rev as 3 out of the 4 injectors were leaking

[syncroand101]

Fitting one of these inline to my pump has helped no end when it comes to bleeding after doing anything on the fuel system..

http://www.ebay.co.uk/itm/UNIVERSAL-8MM ... 0958609028

Saves using the battery and starter to bleed as well..

[bowesy]

Already have one fitted but still no good I have just tried to upload a video bit can't do it off my iphone