Crank shaft pulley

[welder kev]

I removed the pulley to replace the oil seal ,and cant get the pulley back on the shaft,does the keyway move as it looks like its pushed back when i push the pulley on it doesnt locate on the keyway thing.

Sent from my SM-S942B using Tapatalk

[davidoft1]

The key is floating and it’s easy to push it back if you don’t get the a lot lined up

[welder kev]

Great thanks can i just get pliers on it and pull it back into position

Sent from my SM-S942B using Tapatalk

[silverbullet]

Crank pulley key should be a tight fit. If its floading about then the engine may well have been run with a loose pulley in the past and its hammered the keyway out, more of a problem with the heavy triple pulley that has to be torqued up to c.350Nm