Can someone please confirm the centre-to-centre distance of the two M6 holes that are used to mount the late type coolant overflow tank to the rear valance?
It appears to be in the 96-98mm range but defo less than 100mm. I don't have a good tank to check the hole centres.
FYI I'm making a bracket for an alternative tank and the bumper is on the bus which makes measurement difficult, not easy to measure, its wet...
Thanks
Rear valance panel dimension required
Moderators: User administrators, Moderators
-
silverbullet
- Trader
- Posts: 17686
- Joined: 08 Jun 2009, 09:51
- 80-90 Mem No: 6908
- Location: Surrey Syncronaut #156
- Contact:
Rear valance panel dimension required
1985 Oettinger 3.2 wbx-6 Caravelle RHD syncro twin slider. SA Microbus bumpers, duplex winch system, ARC 7X15 alloys,
"Schrödinger's syncro"
Syncronaut #156
"Schrödinger's syncro"
Syncronaut #156
Re: Rear valance panel dimension required
97 mm measured on the valance without the tank in place.
1992 red lle 2.2 subaru 1990 rhd caravelle 2.2 subaru 1986 california import vanagon
-
silverbullet
- Trader
- Posts: 17686
- Joined: 08 Jun 2009, 09:51
- 80-90 Mem No: 6908
- Location: Surrey Syncronaut #156
- Contact:
Re: Rear valance panel dimension required
Thanks, much appreciated 
1985 Oettinger 3.2 wbx-6 Caravelle RHD syncro twin slider. SA Microbus bumpers, duplex winch system, ARC 7X15 alloys,
"Schrödinger's syncro"
Syncronaut #156
"Schrödinger's syncro"
Syncronaut #156