Webasto ST2000D fault

The Tardis factor (interiors, awnings, roofs etc)

Moderators: User administrators, Moderators

Post Reply
Bison535
Registered user
Posts: 130
Joined: 22 Oct 2016, 06:59
80-90 Mem No: 15671
Location: Gibraltar

Webasto ST2000D fault

Post by Bison535 »

My Webasto ST2000D heater; fan runs but heater does not ‘fire up’ ? What are probable faults and remedies in best order to tackle faults?
190 1.6 TD Vanagon

davidoft1
Trader
Posts: 2986
Joined: 27 May 2009, 18:56
80-90 Mem No: 16628
Location: hayling island

Re: Webasto ST2000D fault

Post by davidoft1 »

How long since you last ran it ?

User avatar
slowcoach
Registered user
Posts: 1658
Joined: 06 May 2010, 10:23
80-90 Mem No: 8892
Location: West Yorkshire
Contact:

Re: Webasto ST2000D fault

Post by slowcoach »

Is it getting fuel right to the unit? Is there an air lock in the fuel filter? Is the intake hose clear (no water in it)?

Sometimes needs several on off cycles just to get fuel pumped back to the heater.

Can sometimes be a faff to restart when they're not happy

Sent from my Pixel 4 using Tapatalk

===================
1984 TRAKKA Conversion Subaru EJ20 5 Speed

Bison535
Registered user
Posts: 130
Joined: 22 Oct 2016, 06:59
80-90 Mem No: 15671
Location: Gibraltar

Re: Webasto ST2000D fault

Post by Bison535 »

Thanks for you response and ideas; I need to check!👍🙋🏻‍♂️

Bison535
Registered user
Posts: 130
Joined: 22 Oct 2016, 06:59
80-90 Mem No: 15671
Location: Gibraltar

Re: Webasto ST2000D fault

Post by Bison535 »

Davidtoft1, the heater has not been run for about 3 months ! But I did use to run for short periods before as per recommends!

Maybe lack of use has caused an operational fault!?!

Bison535
Registered user
Posts: 130
Joined: 22 Oct 2016, 06:59
80-90 Mem No: 15671
Location: Gibraltar

Re: Webasto ST2000D fault

Post by Bison535 »

Eventually removed fuel pump and filter to check fuel flow ok. Changed filter but found pump rubber mounting had failed and pump mainly suspended by fuel pipes and electrical connection. The electrical connector was defective so no power to the pump. I made a new cable connection and then the pump worked as normal. Cable tied pump in place and now heater runs ! Needs to be run about 15 mins at least per month :ok

Post Reply