Both sliding door seals are missing from my 1980 2.0 CU.
Schofields stock some none genuine ones that fit left or right for 39.00. Anyone with experience of using them?
They do stock a genuine left hand side seal for 128.00 but not the right.
How do they fit? Glue or clips? (I have no existing seals to reference)
Many thanks.
Sliding door seals
Moderators: User administrators, Moderators
-
- Registered user
- Posts: 49
- Joined: 21 Apr 2024, 17:06
- 80-90 Mem No: 0
Sliding door seals
1980 2.0 CU
-
- Registered user
- Posts: 1682
- Joined: 12 Oct 2005, 11:14
- 80-90 Mem No: 1342
- Location: Wolverhampton.
Re: Sliding door seals
They fit in a groove that goes all the way around the door aperture, there's also a 'channel' along the bottom that's almost always rotten.
Glued in with contact adhesive is what I've done.
I'm pretty sure they are 'handed' so can't see how they can be for either side unless I've misunderstood your post?
They go on a specific way round as well.
Glued in with contact adhesive is what I've done.
I'm pretty sure they are 'handed' so can't see how they can be for either side unless I've misunderstood your post?
They go on a specific way round as well.
2.1 DJ running on carb and LPG.
-
- Registered user
- Posts: 49
- Joined: 21 Apr 2024, 17:06
- 80-90 Mem No: 0
Re: Sliding door seals
Thank you, this is the link to the seals on their website.
https://www.alanhschofield.com/ourparts ... 791AB.html
https://www.alanhschofield.com/ourparts ... 791AB.html
1980 2.0 CU
-
- Registered user
- Posts: 1682
- Joined: 12 Oct 2005, 11:14
- 80-90 Mem No: 1342
- Location: Wolverhampton.
Re: Sliding door seals
They will fit but you need to cut a section out, that's why they're £40 not £130 I guess?
Worth a punt though.
Worth a punt though.
2.1 DJ running on carb and LPG.
-
- Registered user
- Posts: 49
- Joined: 21 Apr 2024, 17:06
- 80-90 Mem No: 0
Re: Sliding door seals
Which bit needs cut out? Sorry for the daft sounding questions but I haven't got the old ones to compare against, all I know is I can see daylight even with the doors shut
1980 2.0 CU
-
- Registered user
- Posts: 1682
- Joined: 12 Oct 2005, 11:14
- 80-90 Mem No: 1342
- Location: Wolverhampton.
Re: Sliding door seals
They're made up of 4 pre moulded corner pieces and 4 straight bits (to make up a square) one of the straight bits is too long so you'll need to cut it where it joins the corner and reduce it's length accordingly, super glue it back together.
There's also a piece that fits where the latch goes so make sure that's in the right place.
There's also a piece that fits where the latch goes so make sure that's in the right place.
2.1 DJ running on carb and LPG.
-
- Registered user
- Posts: 49
- Joined: 21 Apr 2024, 17:06
- 80-90 Mem No: 0