Westfalia California routing wiring loom for charger and eberspacher

[sweetaswesty]

I'm finally at the stage of refitting the water and kitchen cabinets and then the seat/bed on our California. But I just need confirmation of the route for the section of the wiring loom that goes under the seat and connects the charger and the eberspacher.
The ply flooring doesn't continue under the seat but is supplemented by sections of fibreboard which are stapled to the ply. This leaves a small gap between the edge and the rising panel behind the seat and this covered by a galvanised metal strip which is stapled to the fibreboard also.
So I'm pretty sure that the cabling tucks in behind the fibreboard and underneath - rather than on top of - the galvanised strip. Does this  sound right? I just want to be sure as otherwise it's going to be another case of two steps forward and one step back as I do it right the second rather than first time.
Thanks for any advice.
Here are some pics which hopefully show what I'm talking about.

 

[clift_d]

I’m not sure that I recall the galvanised strip being present in our Club Joker, but my recollection is of that wiring being the last thing out, and the first thing back in, when we removed our bench seat, i.e. it was at the bottom.

[sweetaswesty]

Thanks! That’s helpful.

[tlg]

having started removing units to upgrade wiring and sound proof i can also confirm it goes under the galvanised sheet.