Choke wire fire

An alchemy of sparks, copper wire and earth

Moderators: User administrators, Moderators

Post Reply
MagicWagon
Registered user
Posts: 263
Joined: 17 Jan 2016, 19:38
80-90 Mem No: 0

Choke wire fire

Post by MagicWagon »

Had a bit of a scare this evening. I was adjusting the automatic chokes on my 83 2.0L air cooled as it was running very fast on choke. I took off the air box pipes, adjusted the chokes so butterfly was almost closed at cold, tightened up and tried to start. It didn't want to start at all. I went round the back and the engine compartment was full of smoke, and the wire from the coil to the left-hand choke was glowing bright orange. I quickly turned the ignition off and the glowing and smoke eventually stopped. The wire was melted through.
I'm assuming/hoping the wire was just old and damaged, but it seems a strange coincidence that it should happen when I was adjusting the chokes. 
Could a faulty choke cause the extra load to melt the wire ? or shall I just change the wiring and try again ? If the latter, I'm tempted to put a fuse between the coil and the chokes to be on the safe side. What would be a suitable fuse rating ?
And advice would be most welcome.
1983 2.0L Air Cooled Devon Moonraker

davidoft1
Trader
Posts: 3116
Joined: 27 May 2009, 18:56
80-90 Mem No: 16628
Location: hayling island

Re: Choke wire fire

Post by davidoft1 »

Most likely the terminal touched the body

User avatar
syncroandy
Trader
Posts: 1920
Joined: 18 Oct 2005, 18:15
80-90 Mem No: 851
Location: North Lancs. UK
Contact:

Re: Choke wire fire

Post by syncroandy »

Be aware the current that melted that wire likely came through the ignition switch and every connection point between that and the melted wire. I have seen CE1 relay plates where the ignition output pin to the engine-bay was melted to the plug due to overloading. So it may be worth giving the whole circuit a check, and/or carrying a spare ignition switch in the event of problem. On the T3, the ignition switch output to the engine-bay is not fused. It uses 1.5mm wire, which suggests a nominal rating of ~15A. HTH
Syncrosport (taking a break as of summer 2024)
Volkswagen Transporter, reloaded.

252 GC5 EJ25 AAN L90D

User avatar
bigherb
Registered user
Posts: 2582
Joined: 27 Mar 2008, 13:50
80-90 Mem No: 5789
Location: West Kent

Re: Choke wire fire

Post by bigherb »

More likely, the choke terminal either touched the throttle linkage or the ceramic part of the choke has failed and allowed a short inside.The original wireing is only 0.5mm2 cable, it is meant as sacrificial if there is a fault, so the main wiring loom does not burn out.
 
1982 Camper 1970 1500 Beetle Various Skoda's, Ariel Arrow

MagicWagon
Registered user
Posts: 263
Joined: 17 Jan 2016, 19:38
80-90 Mem No: 0

Re: Choke wire fire

Post by MagicWagon »

Many thanks for the replies. Turns out BigHerb was right on the money. I found that with the choke removed, but still connected (with new wiring), the choke body was live.  I have fitted a fuse on the main ignition wire in the engine bay before the coil. I tried a 5amp, which blew. Changed it to 10amp and it seems OK.
Interesting about the wire being thin so it is sacrificial. I replaced the wire with thicker gauge, but it sounds like that was the wrong thing to do in that case.
Not sure I like the idea of the wire being the fuse, so I may re-do that new bit of wire with something thinner, and/or stick a low value fuse in the wire to the chokes.
Now to try sourcing a replacement choke, which looks like it's harder than it sounds.
1983 2.0L Air Cooled Devon Moonraker

Rosie n' Jim
Registered user
Posts: 249
Joined: 06 Sep 2020, 06:40
80-90 Mem No: 0

Re: Choke wire fire

Post by Rosie n' Jim »

I've seen them on ebay a while back. Be aware however that they are 'handed'. You cannot fit left to right, or visa versa.
​
1982 Holdsworth poptop. 2L CU Aircooled.
1982 Danbury tintop Caravelle. 2L CU Aircooled.

MagicWagon
Registered user
Posts: 263
Joined: 17 Jan 2016, 19:38
80-90 Mem No: 0

Re: Choke wire fire

Post by MagicWagon »

I've drawn a blank searching for these. I ordered one from Serial-Kombi, but they cancelled the order due to brexit as they have a minimum £155 order value to UK.
Part number I believe is 021129191E if anyone has any info where I might get one.
1983 2.0L Air Cooled Devon Moonraker

davidoft1
Trader
Posts: 3116
Joined: 27 May 2009, 18:56
80-90 Mem No: 16628
Location: hayling island

Re: Choke wire fire

Post by davidoft1 »

MagicWagon wrote: ↑21 Oct 2021, 06:59 I've drawn a blank searching for these. I ordered one from Serial-Kombi, but they cancelled the order due to brexit as they have a minimum £155 order value to UK.
Part number I believe is 021129191E if anyone has any info where I might get one.


I have some spares, what side is it ?

MagicWagon
Registered user
Posts: 263
Joined: 17 Jan 2016, 19:38
80-90 Mem No: 0

Re: Choke wire fire

Post by MagicWagon »

Hi Davidoft1 
It's the left side. :D
 
1983 2.0L Air Cooled Devon Moonraker

Post Reply