Solex pdsit carbs

[Cookie]

Evening all,

Should there be anything in this hole? It looks like it has a thread but in every picture I see and including my own it is empty.

Cheers
Cookie

[davidoft1]

Evening all,

Should there be anything in this hole? It looks like it has a thread but in every picture I see and including my own it is empty.

Cheers
Cookie

There a clip on some to hold the air intake on , it would have a shape on the filter , does yours have rubber or plastic ends at the carb ?

[Cookie]

This is mine prior to being cleaned. It looks like there’s a thread inside and it threw me!

Mine are rubber if you’re referring to the pipes that seal over the carb. Someone has used a cable tie previously to keep it on.

Cheers
Cookie

[davidoft1]

This is mine prior to being cleaned. It looks like there’s a thread inside and it threw me!

Mine are rubber if you’re referring to the pipes that seal over the carb. Someone has used a cable tie previously to keep it on.

Cheers
Cookie

The rubbers you have just push onto the carb , the clip isn’t needed on yours , if the ends were plastic then then clip would be used

[Cookie]

That’s one more question ticked off the list!

Many thanks
Cookie

[matteo]

Hi Cookie,

I agree that that the port is confusing. To confirm that on my PDSITS with rubber air hoses nothing connects there - photo below.
Hope the set-up goes OK.

[Cookie]

Cheers Matteo