1990 Singlecab II

Post by **DoubleOSeven** » 26 Mar 2021, 18:13

“Above or below, who knows where the o-ring goes” - kinda rhymes, but that doesn’t help.

Anyone?

BENTLEY:

7ZAPVW:

Post by **ajsimmo** » 26 Mar 2021, 20:21

Above.

Sent from my ONEPLUS A3003 using Tapatalk

Post by **DoubleOSeven** » 26 Mar 2021, 21:36

Nice one Andrew

Post by **DoubleOSeven** » 27 Mar 2021, 07:48

Post by **DoubleOSeven** » 27 Mar 2021, 11:14

Where it is at the moment:

Post by **DoubleOSeven** » 27 Mar 2021, 12:47

Is the black wire that shares sleeving with red 12V feed (hedgehog/carb heater/choke) for the carb solenoid? If not, where do you get the carb solenoid feed from? Thanks.

Well, it comes on and on with ignition so I’ll use it

Post by **DoubleOSeven** » 27 Mar 2021, 14:09

Air lines are on and clutch slave pipe. Rigged up a temp fuel supply but starter motor not engaging when I turn the key, so I’ll get into that next. But good progress today, nearly...

Post by **DoubleOSeven** » 27 Mar 2021, 14:26

When this relay lever is engaged I’ve got all the gears but the ball keeps popping out. The rubber boot is shot, but is this all it needs to prevent it popping out?

Post by **slowcoach** » 27 Mar 2021, 19:01

DoubleOSeven wrote:When this relay lever is engaged I’ve got all the gears but the ball keeps popping out. The rubber boot is shot, but is this all it needs to prevent it popping out?

Ball should definitely stay put without the rubber boot. Check the rod bush carrier (right below the selector ball) is pushed up far as it will go, the two bolts into the gearbox housing are slotted for adjustment

Post by **DoubleOSeven** » 31 Mar 2021, 11:22

https://youtu.be/Hf_Bd5vrB9o

First Turn ...

Post by **DoubleOSeven** » 31 Mar 2021, 12:24

My coil reads:

Primary 1.1 Ω (stand alone leads were 0.1)
Secondary 2.9k Ω

Primary looks out of spec. but would this cause no spark?

Post by **300CE** » 31 Mar 2021, 19:29

Timing all good Martin?

Post by **DoubleOSeven** » 31 Mar 2021, 19:42

It’s not no. I’ve had the dizzy out so I’ve no idea where it is, timing wise. But it should still spark, just won’t be at the right time. I’ll try a few things tomorrow and report back. Getting close ...

Post by **300CE** » 31 Mar 2021, 21:01

mine was 180 degrees out and was just turning over. Adjusted and she went straight away - keep us updated mate.

Think I have another coil you can try if needs be!

Post by **DoubleOSeven** » 02 Apr 2021, 13:28

Holding pin was missing so no magnetic field being created.

...but alas, this isn’t the problem. Still no spark.
However, it can only be one or a combination of these things though; coil, distributor, my re-wired loom. The coil is second hand, the distributor - I’ve changed the hall sensor, the wiring - I made myself! I’ll test the ignition amplifier while I’m at it and check the coil is actually getting 12V.
Procedures are in the Bentley manual, page 28.36

Club 80-90 Forums