Cleaned up my tinware and fitted speedshop exhaust

[Cobra88]

Spent a couple of evening fitting the Speedshop pipe.

once fitted my rusty tinware looked poop so removed the rear exhaust and refurbed the tinware

noticed some separated engine mounts and fitted a new set and cleaned all the parts.

might do the shields black as it now looks a bit bright when looking down into the bay
but im really happy with the exhaust in both quality and fit.

Regards
Rick

[itchyfeet]

looking good.
I thought about the speedshop but doesn't fit well with a 2.1.

shame they don't stay shiny.

[Cobra88]

Hi Itchy

Are you sure or do you mean not suited to the bigger capacity

mine is 1970cc ish as it had a big bore kit fitted when it was rebuilt

Have seen them fitted on the 2.1 !

much neater than the factory maze of pipes and I would think less restrictive too.

I went speedshop as it's a bargain and looks a lot better than anything else I could find sub £1200

Rick

PS I thought the silencer support bracket looked pants so reshaped it and reversed it so it bolts on out of view
much better

[itchyfeet]

2.1 has an oil cooler so oil rilter is further out.
need to use a smaller oil filter which ai wasn't happy about.

anyway fine on a 1.9

[Cobra88]

Ah I see

How about a remote filter ?

[DoubleOSeven]

Good work on the support bracket, I was just about to ask about it until you mentioned it. It is the only mod Speed shop should look into.
Nice clean engine bay, looking good.

[itchyfeet]

Enjoy it while it lasts, this is mine now