1.9/2.1 Cylinder head differences

[ajsimmo]

That sounds like recessed valve seats. The valves sit deeper in the head as the seat burns away, therefore the valve tops move out towards the rockers, eventually having no adjustment left. Do you have any pics of the head before fitting? If the valve head is sitting flush (or below) it's had it.
See pics for good and bad:

Sent from my ONEPLUS A3003 using Tapatalk

[ajsimmo]

Also are all the pushrods seated properly in the lifters? If not, you'll get this problem.

Sent from my ONEPLUS A3003 using Tapatalk

[lucas]

Thanks for the reply, the valves were certainly not recessed into the head like the in the picture, I did spend a fair bit of time with the grinding paste ensuring no pitting in the seats so would have sparred this. So it sounds like a follower issue? But all 4? How do I go about confirming/ fixing that?

[itchyfeet]

Thanks for the reply, the valves were certainly not recessed into the head like the in the picture, I did spend a fair bit of time with the grinding paste ensuring no pitting in the seats so would have sparred this. So it sounds like a follower issue? But all 4? How do I go about confirming/ fixing that?

Answered on your other thread this thread is about head differences

[itchyfeet]

stolen those pics Andrew and made a reference pic

[itchyfeet]