Best to buy a new panel?

[Swebby]

I was dealing with a bit of rust which called for me to take part of the rear bumper off. Managed to find a lot more rust!
My thoughts are it is probably better to get a new panel put in rather than cut out offending areas and weld. But any thoughts are welcome.


Sent from my BBB100-2 using Tapatalk

[fazzer]

Easy panel to replace I'd cut it out and all surrounding rot and put new panel in.

[Swebby]

Cheers. Do you know if it possible to get new wheel inner arch sealant like the original stuff? Seen some stuff on brickwerks but says it needs a special spray but they don't elaborate any further.

Sent from my BBB100-2 using Tapatalk

[fazzer]

I use stonechip in an aerosol can and put a few coats on it,leaves a nice textured coating.

[Swebby]

Sounds good, I will give it a go.

Sent from my BBB100-2 using Tapatalk