1.9 dg 1987 only get 10ltr coolant back in ?

[Oldiebut goodie]

I always put the 50% in then top up with water never worrying then about how much has gone in.(or how much was left behind originally) I would do it the same on those funny engines also.I have never understood the point of ready mixed - I thought that was concrete! One good run and it will be mixed well enough.

[adie89]

I always put the 50% in then top up with water never worrying then about how much has gone in.(or how much was left behind originally) I would do it the same on those funny engines also.I have never understood the point of ready mixed - I thought that was concrete! One good run and it will be mixed well enough.

You should always premix coolant. If unmixed coolant gets hot it turns to jelly and clogs your coolant passages.

[Oldiebut goodie]

Never had that in 50 years!

[Oldiebut goodie]

It does hide well. I think you have to pick it up, turn it over and shake it to get it all out.

[AngeloEvs]

I remove the bottom hose from the rad and there is still at least 8 litres left. I think there are drain points on each cylinder head but I don't much fancy removing them and not sure wether it would make much difference.

[ash1293]

I'll have to double check next time round but when I changed coolant I got around 12-14ltrs out using a decent shop vac.
First go round through the header tank and then when no more was flowing I dropped bottom hose of radiator and put the vac on that hose (not the radiator itself)

Not knowing the age, or more importantly spec of the coolant in the van I then filled with water and repeated process a coupel of times before fininlly filling up with correct stuff.

[Aidan]

if you don't open the bleed screw in the rad before draining down the rad stays mostly full especially if you drain down at the engine end and with the thermostat shut you won't be flushing the rad unless you do it at the front, ideally to flush the rad you'd disconnect both hoses at the front and then run a hose both ways through the rad till it runs clean

[itchyfeet]

I always put the 50% in then top up with water never worrying then about how much has gone in.(or how much was left behind originally) I would do it the same on those funny engines also.I have never understood the point of ready mixed - I thought that was concrete! One good run and it will be mixed well enough.

I do the same never had any problems, never get all the water out after flushing.

[123-jn]

I always have this after putting an engine back in, the water hides in the rad and in the lower stretches of tubes. I drained mine to get the engine out the other day and drained 11 litres.