How are you measuring the voltage & what model Zig do you have ?
When I fitted a s/h Zig charger to my Autosleeper I tested it with no load and is was giving over 15V with a multimeter. Fearing it was damaged I ended up taking mine apart and discovered that there's just the transformer, capacitor and a standard / common bridge rectifier inside. When attached to the van it's providing around 14.2-14.4 v, measured across the leisure battery.
https://club8090.co.uk/forum/viewtopic.php?f=39&t=161757
zig unit on site button over voltage
Moderators: User administrators, Moderators
- 937carrera
- Registered user
- Posts: 3600
- Joined: 05 Apr 2015, 19:29
- 80-90 Mem No: 16333
- Location: N Yorks.
Re: zig unit on site button over voltage
1981 RHD 2.0 Aircooled Leisuredrive project, CU engine
1990 RHD 1.9 Auto Sleeper with DF/DG engine
1990 RHD 1.9 Auto Sleeper with DF/DG engine
- 937carrera
- Registered user
- Posts: 3600
- Joined: 05 Apr 2015, 19:29
- 80-90 Mem No: 16333
- Location: N Yorks.
Re: zig unit on site button over voltage
Assuming your friend is an electronics engineer mention the bridge rectifier (4 or more diodes in a single component) to him, he should be able to recognise if that could be the problem. I was considering replacing mine and when I went to look it was a common component and only about £4.
In the end I left mine out of the van and rigged up a system to test the charger and monitor voltage as a battery charged without installing in the van. Seemed OK, if a little higher than I would have expected and has been fine when installed.
In the end I left mine out of the van and rigged up a system to test the charger and monitor voltage as a battery charged without installing in the van. Seemed OK, if a little higher than I would have expected and has been fine when installed.
1981 RHD 2.0 Aircooled Leisuredrive project, CU engine
1990 RHD 1.9 Auto Sleeper with DF/DG engine
1990 RHD 1.9 Auto Sleeper with DF/DG engine